Blog posts tagged with 'Spiral Coils for Heat Exchanger'

Albina just bent and welded 27 lengths x 20 ft to make 3 cooling coil assemblies for a refrigeration project. All material processed was 1¼” Sch80 SA106B seamless. Albina roll bent the material to the requested coil configurations. We trimmed the coils to size and draw bent the terminals and welded the terminals to the coils. Each cooling coil assemble was pressure tested after fabrication for leaks. Once we completed this project we shipped it across the country to Maryland!

Albina spiral coiled ½" OD X .065" WALL stainless steel tube heat exchanger for an industrial application. We were supplied with only the existing coil to reproduce from. The coils were bent in one continuous piece that spirals down on the inside and then steps out and spirals back over itself. The sheet between was not needed to complete the bends but was left in place to match the existing design. [caption id="attachment_1137" align="aligncenter" width="640"] Spiral coiled ½" OD X .065" WALL stainless steel tube heat exchanger. [/caption] [caption id="attachment_1138" align="aligncenter" width="640"] Bent in one continuous piece that spirals down on the inside and then steps out and spirals back over itself. [/caption]