Category Archives: Stainless Steel Pipe Bending

Curved Steel Beer Taps at 10 Barrel Brewing in Bend, Oregon

We were recently floating the Deschutes River in Bend, Oregon and after a day of fun, we decided to go grab lunch and cool beverage at one of our favorite locations, 10 Barrel Brewing. As we looked at the menu, and admired the new remodel of the restaurant, we noticed the beer taps! We recently bent 1-1/2” OD x .065 wall T304 Stainless steel #4 finish. These are 90 degree bends on a 2-3/4” Center line radius. How exciting to see our work on display at such a hip location on Galveston Street!

Curved Steel Handrail on the Vancouver Waterfront Walkway

We recently completed a handrail project for a walkway around the Vancouver, Washington waterfront park. The projected consisted of

12 pieces of 2½” SCH40 T304 S/S
18 pieces of 1¼” SCH40 T304 S/S
17 pieces of 2½” SCH40 A53B ERW
26 pieces of 1¼” SCH80 A53B ERW

We bend handrails for commercial, recreational, transportation and residential applications. Handrail Kits Are Available: Bent and trimmed per drawing, mid-rails trimmed and coped, assemblies supplied as individual parts or fabricated complete. Call us for your next handrail project!

Curved Steel Handrail on the Vancouver Waterfront Walkway

Curved Steel Handrail on the Vancouver Waterfront Walkway

Stainless Steel Pipe Bending of Small Parts for Manufacturing Application

We recently completed a very difficult job in which we bent 3″ OD X .065″ WALL T304 Stainless Steel POLISHED, 2½” OD X .065″ WALL T304 Stainless Steel POLISHED, and 1/2″ OD X .065″ WALL T304 Stainless Steel Polished for a manufacturing customer. The really tight bends in the picture below are elbows (butt-weld fittings) that are purchased off the shelf at a pipe supply house. The bends we did are the larger radii bends. Albina is a reliable vendor when it comes to producing bent parts for manufacturing applications. When applicable, we can provide same day and/or shutdown services which is a huge plus for customers that rely on equipment running 24 hours a day. Albina is also qualified to process NQA-1 work for certified NQA-1 shops.

Bent Steel Parts for Manufacturing Application

Keep Things “COOL” at Albina

Albina just bent and welded 27 lengths x 20 ft to make 3 cooling coil assemblies for a refrigeration project. All material processed was 1¼” Sch80 SA106B seamless.
Albina roll bent the material to the requested coil configurations. We trimmed the coils to size and draw bent the terminals and welded the terminals to the coils. Each cooling coil assemble was pressure tested after fabrication for leaks. Once we completed this project we shipped it across the country to Maryland!

Spiral Coils for Industrial Heat Exchanger

Albina spiral coiled ½” OD X .065″ WALL stainless steel tube heat exchanger for an industrial application. We were supplied with only the existing coil to reproduce from. The coils were bent in one continuous piece that spirals down on the inside and then steps out and spirals back over itself. The sheet between was not needed to complete the bends but was left in place to match the existing design.

spiral coiled ½" OD X .065" WALL stainless steel tube heat exchanger

Spiral coiled ½” OD X .065″ WALL stainless steel tube heat exchanger.

spiral coiled ½" OD X .065" WALL stainless steel tube heat exchanger

Bent in one continuous piece that spirals down on the inside and then steps out and spirals back over itself.