STEEL BENDING PROFILES: ANGLE
We bend all sizes of angle that the mill produces, up to 8” x 8” x 1¼”. The first two numbers in angle specify the length of each leg. The third number specifies the thickness of the angle.
We can bend all types of angle as well; including aluminum, stainless and carbon steel. Carbon angle (mill produced) is classified as ASTM A36 resulting in a yield point (PSI) of 36,000 minimum.
We bend all stock lengths as well as non-stock lengths. Stock lengths range from 20 to 40 feet.
Angle is produced with equal legs and unequal legs. Unequal legs would measure differently on the horizontal leg versus the vertical leg.
We have the ability to bend angle with the leg in, leg out, heel in, heel out and heel up.
We also have the ability to bend bulb flat. Bulb flat is similar to angle with one of the legs cut down to a very short "stub". We can bend bulb flat with the stem out and the stem in. We can bend all mill sizes produced up to 430 mm x 20 mm (16.93” wide x .787” thick).
Bent angle can be used for many different applications. The most common application would be angle flanges which are full circles that are used to join sections of pipe together. Bent angle is also used for canopies, roof trusses and tunnel shoring applications.
Steel Bending Angle for Healthcare Building
Steel Bending Angle for Whole Foods Grocery Store Entry
Steel Bending Angle Leg Out
Steel Bending Angle for Holy Redeemer Church Roof Trusses